Nonlinear Analysis of Bearing Characteristics of Stiffened Deep Cement Mixing Piles under Vertical Loading

Stiffened deep cement mixing (SDCM) piles are composite piles that combine the advantages of single large-diameter deep cement mixing (DCM) and precast concrete piles. They comprise precast concrete piles as the core and cast-in-place DCM piles as the outer layer. This study evaluates the bearing characteristics of SDCM piles under vertical loading. The composite modulus of elasticity of SDCM piles is first introduced and determined using the area-weighted average method. Then, the reliability of the proposed method is described by comparing the calculated results with the findings of the existing literature. Furthermore, a nonlinear simplified analysis method based on the load transfer method is proposed for vertical bearing characteristics of equal- and short_core SDCM piles under vertical loading. This method is developed by the finite difference method. The accuracy of the simplified method is validated by comparing its results with those from existing tests, theoretical analysis, and finite element simulations. The results of their study indicated that the area-weighted average method calculates the composite modulus of elasticity of the composite pile section of the SDCM piles with an error below 0.5% compared to the analytical method. This finding represents sufficient accuracy. The simplified calculation method established in this study is computationally stable. When the iteration factor is set to 10−6, as the number of discrete nodes n on the pile increases, the calculation results are stable with a good convergence when n > 30. The vertical bearing capacity and pile top stiffness of SDCM piles increased with the length of the core piles. There was a reasonable core-to-length ratio for SDCM piles in specific scenarios. An excessively long DCM pile section made its lower part force-free for a given length of core piles. The appropriate length of core piles should be determined in actual projects to avoid unnecessary material waste. An optimum ratio of core piles for SDCM piles was determined. Beyond this optimal value, an increase in the ratio of core piles controlled the pile settlement in a limited manner.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.