Water Vapour Resistance of Ceiling Paints—Implications for the Use of Smart Vapour Barriers in Compact Wooden Roofs

Smart vapour barriers enable building envelopes to dry toward the interior side. This property can be used in compact wooden roofs to create more slender structures by placing the wooden load-bearing elements inside the insulation layer. There is, however, some concern that the ceiling assembly on the interior side may inhibit inward drying by trapping moisture between the vapour barrier and the ceiling boards. This article examined the water vapour resistance of gypsum boards painted with two, four, and six layers of typical ceiling paints. WUFI® 2D simulations were conducted to assess the risk of mould growth in compact wooden roofs with painted board ceilings. It was found that a painted ceiling board may exhibit an equivalent stagnant air layer thickness (sd value) between 0.074 m for two layers of the most vapour-open paint and 0.53 m for six layers of the least vapour-open. For an unpainted board, the sd value was measured to be 0.071 m. The difference was not found to make a substantial impact on the drying of a typical compact wooden roof. The application of paint may cause the assembly to dry at a slightly slower rate but was not found to present a notably higher risk of mould growth, even under unfavourable conditions.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.